Metal cutters
Metal cutters — My Print XD-322, Pro A4 and Pro A2 guillotines: choose a metal cutter to suit your sheet.
Below: how to choose a metal guillotine for the width and thickness of your sheet, which metals the cutter cuts and what to cut aluminum sublimation plates with.
Which metal guillotine to choose
In short: metal cutters are chosen by cutting width, type of metal and sheet thickness. Compare the models in the table and send us the material details to confirm your choice.
The XD-322 benchtop guillotine up close
The My Print XD-322 guillotine metal cutter is a guillotine shear for sheet metal. Data are from the product page.
Steel blades
The upper and lower blades are made of steel; according to the product page, this makes them strong and makes cutting easier.
Protective shield
The shield over the blade protects fingers from injury and holds back offcuts of material.
Metal cutters: format and cutting width
Format and cutting width are from the product pages.
| Guillotine cutter | Format | Cutting width |
|---|---|---|
| My Print XD-322 A4 | A4 | 32 cm |
| My Print Pro A4 | A4 | 32 cm |
| My Print Pro A2 | A2 | 62 cm |
A cutter for aluminum sublimation plates
Plates from the “Metal for sublimation” section are metal blanks made of aluminum with a special coating, 0.35–1 mm thick; the size and thickness are given in the name of each sheet. Below: choosing a model by cutting width.
Metal sublimation plates of 0.35–1 mm are within the XD-322 cutting thickness given on its product page (up to 2 mm). For other materials, and for the Pro A4 and Pro A2, we will confirm the material and sheet thickness while helping you choose.
How to choose a metal cutter: 3 steps
Tell us the metal, the thickness and size of the sheet and what you cut from it — we’ll suggest a model and cutting width.
Materials and other cutters
FAQ about "Metal cutters":
The XD-322 product page gives a general cutting thickness of up to 2 mm. For aluminum, copper and iron, write to us with the sheet thickness, and we will confirm the capabilities of the XD-322, Pro A4 or Pro A2 for your material.
The XD-322 product page lists printed circuit boards and plastic among the materials for cutting. Tell us the type and thickness of the material, and we will check the permissible thickness for your sheet.
A manual one: the XD-322 cuts with a lever, by hand, and the cutter itself is a benchtop model, 530 × 330 × 300 mm. The thickness limits are in the answer above.
For the XD-322, there is a separate blade for the My Print XD-322 A4 guillotine metal cutter. For the Pro A4 and Pro A2, write to us with the cutter model, and we will check blade compatibility.
For sheet metal, choose the metal cutters in this section; for paper, paper cutters.







