If the first sticker is cut accurately but the contour gradually moves into the image farther along the sheet, stop the run. A single position adjustment may align the start without removing an increasing error. First check the printed dimensions, material feed and registration-mark reading.
Make a small control print
Use a test file and registration-mark layout supported by your model. Place identical contours at the start and end of the sheet and, where the format permits, near both edges. Do not experiment on a customer's order.
At each point, record the direction and amount of cut displacement: along the paper feed or across it. Photos of the start, middle and end reveal patterns that one sticker cannot show.
Compare the error pattern
- All contours have approximately the same displacement. Check print-to-cut position alignment.
- The start is accurate but the error increases gradually. Check printed scale, cutting distance and material feed.
- The left and right edges diverge. Check skew and loading first.
- The displacement jumps near a mark. Check mark reading and section-based settings where the model supports them.
These are directions for investigation, not final diagnoses. Different faults can produce similar patterns.
Separate incorrect print scale from cutting error
Before cutting, measure a control distance on the print and compare it with the file. If the image is already stretched or compressed, first check scaling in the print software and printer feed. Cutter compensation should not conceal an incorrect print.
If the printed dimensions are correct but the blade path increasingly leads or trails the image, find the cutter manufacturer's procedure for checking cutting distance and feed. Menu names and permitted values are model-specific. After one change, repeat the same test and compare the entire sheet, not just its first contour.
Check loading and registration marks
The material should be flat, without folds, unwanted tension or skew. Load it in the permitted roller area using the manufacturer's procedure. If feed remains uneven, do not hide it with an arbitrary scale adjustment.
Use only a supported mark layout. Check contrast, orientation, the effect of lamination and software settings. An optical sensor does not imply support for every mark format or for dividing long jobs into sections. Removing and reloading material may require a separate alignment procedure.
Do not confuse contour accuracy with cutting depth
Blade force does not correct an incorrect scale. If the contour aligns but the film is not cut through or its liner is damaged, check test cutting: blade, force, and speed. That is a different problem.
When to contact service
Do not continue production if the error increases, marks cannot be read or the material feeds unevenly after the manufacturer's checks. Do not dismantle the cutter or clean internal sensors based on an unverified tip.
Prepare the model, software and firmware versions, test file, material name, lamination details and photos of the control points. This supports a useful service enquiry without inventing a universal tolerance.
View MyPrint cutting plotters and verify the exact model’s process.
