If a laminating pouch gets stuck in a pouch laminator, do not pull it by force. Switch on reverse and the rollers will bring the pouch back out through the inlet. If there is no reverse, switch the laminator off first, then hold the release lever and pull the pouch straight out through the inlet. If it does not come without force, unplug the machine and take it for service.
Reverse or ABS lever: how to get the pouch out
Do not feed another pouch or try to push the jammed one through with a second sheet. Reverse is a button or switch with a back arrow on the panel (at My Print, the LM-330iD model). The release lever is a slider marked ABS on the back, next to the outlet (5 in 1 and 6 in 1 models). Even if the pouch has disappeared inside completely, try reverse or ABS first. The pouch and rollers are hot: hold the pouch by its edge and keep your fingers away from the slot.
Electric reverse
Switch on reverse
Rollers bring the pouch out through the inlet
Keep reverse on until the pouch comes out of the inlet. When the edge appears, pull it gently in the same direction, without jerking. Then switch back to forward feed.
Manual release (ABS)
Switch the laminator off
Slide and hold ABS
Pull the pouch out through the inlet
Hold the ABS slider across with one hand and pull the pouch back through the inlet slowly and straight with the other. Then let go of the slider.
Reverse brings the pouch out with the rollers; with ABS, you pull it out yourself.
Pouch will not come out? Stop here
Edge still not showing, or the pouch will not move without force? Stop: switch the laminator off and unplug it. Do not reach into the slot with fingers or tools, and do not open the casing. Film wrapped around a roller is a job for a service technician.
Why feed direction matters
The two sides of a pouch are joined by a factory seal along one edge. When the seal goes first, the rollers take both films in together. Feeding an open edge first or feeding at an angle can crumple the film and cause a jam. The seal is easy to find: it is the only edge that does not open.
✓ Sealed edge first
Both sides enter together
✗ Open edge first
Risk of crumpling and jamming
Top view. The solid blue band marks the factory seal; the dashed line marks the open edge of the pouch.
Before the next pouch
Once the pouch is out, look into both slots. If a piece of film is left that neither reverse nor ABS will bring out, do not run a test: this is a job for service. If the slots are clear, switch to hot mode and, once warmed up, run a sheet of plain paper folded in half through 2–3 times, fold first: it picks up adhesive residue from the rollers. Do not pour solvent into the slot.
- Use a new pouch that fits the sheet size, in a thickness your laminator accepts. Do not trim a pouch before laminating or run it empty.
- Place the paper straight, close to the factory seal, with equal side margins. Feed sealed edge first, centred in the slot. If the rollers have already taken the pouch at an angle, use release or reverse.
- Leave at least 50 cm of clear table behind the laminator so the pouch can exit fully. Take each pouch from the outlet straight away and lay it flat to cool.
Wait for the ready light, then run one test pouch with a sheet of the same size and thickness. It should exit straight, without a folded edge. If it jams again although you fed it correctly, stop trying and take the laminator for service.
