Acrylic for sublimation with metal support, glossy white, 101.6*101.6 mm, thickness 3 mm (12217)

To apply an image to an acrylic blank, you will need:

• Heat press for T-shirts or multifunctional heat press;
• Sublimation printer filled with sublimation ink;
• Sublimation paper;
• Thermal tape;
• Акрил для сублимации с металлической опорой глянцевый белый 101,6*101,6 мм, толщина 3 мм

The process of printing by the sublimation methodАкрил для сублимации с металлической опорой глянцевый белый 101,6*101,6 мм, толщина 3 мм consists of the following stages:

1. Print the prepared image on sublimation paper in direct (not mirror) image;
2. Let the sublimation paper dry. If the printing was done on matte photo paper, then this step can be skipped, since the ink is absorbed into the paper almost instantly;
3. Remove the protective film from the white side of the acrylic;
4. Cut out the image and attach it to the white side of the acrylic and fix it with thermal tape;
5. Place the blank in the heat press;
6. Set the temperature to 180 ° C and time for 100 seconds;
7. Apply light pressure (less than average).

Cooling:

1. After the transfer process is complete, carefully remove the paper;
2. It is recommended to place the workpiece under a cold press or other flat weight to avoid deformation during cooling;
3. After complete cooling, remove the protective film from the other side of the acrylic.

The process is complete. Акрил для сублимации с металлической опорой глянцевый белый 101,6*101,6 мм, толщина 3 мм is now not just a workpiece, but a finished product with a unique image or photograph.