A badge usually comes apart because the crimp is too thick (two stuck film discs or paper that is too heavy) or because the handle was not pressed all the way. First make a new badge with the same print and exactly one film disc, pulling the handle all the way down on both presses. If that does not help, repeat on ordinary 80 g/m² office paper; if the back still falls out, check the parts.
What prevents the edge from closing
With button badge blanks, the folded metal rim of the front shell holds the back in place. The paper and clear mylar film also tuck into this crimp. An extra film disc or stiff card makes the crimp thicker, and the edge does not close fully.
Before loading: count the layers
One film disc
Two discs stuck together
This is how the layers sit in the first die: front shell at the bottom, paper above it, film on top. Two stuck discs can easily pass for one.
Separate the film first
Take fresh parts. Slide the edges of the clear discs apart with your fingertips and separate out one. Also check that two metal front shells have not nested inside each other.
Make a badge with the same paper and exactly one film disc. Keep the press, die set and circle cutter unchanged between samples. Load the front shell dome up into the first die, the paper on it picture side up and the film on top; put the back into the second die pin side down. Pull the handle all the way down on both presses: a short stroke is one of the most common reasons a back later falls out. If the mechanism jams, stop pressing.
Inspect the entire back edge and press the back lightly with a finger: it should stay in place, and the film should remain inside the crimp. If it holds, make one more badge to be sure. If you found two stuck discs, shake the stack loose before work and take the discs one at a time. Do not add a second film for strength either. If your paper is heavier than 100 g/m², go straight to the office-paper test.
Now change only the paper
If the edge still will not close with one film disc, use paper that has already produced sound badges with this setup. If no paper has worked yet, use ordinary 80 g/m² office paper. For the run, stay within 80–100 g/m²; photo paper of 160 g/m² or more and card are too thick for a crimped badge. Cut the circle with the cutter made for your die. The insert diameter is listed in the die and blank specifications: 70 mm for a 58 mm badge. A larger or uneven circle will not fit into the crimp, and a smaller one will not reach it. Load one paper layer, without extra lamination or an adhesive backing.
First make a badge with a blank paper circle. If it closes, repeat with your design printed on the same paper. Use fresh parts and one film disc each time. This shows what gets in the way: the paper itself or the print on it.
One paper stock, two samples
Make the second sample only after the first one succeeds. Keep circle size, parts and assembly method unchanged.
| Blank circle | Printed circle | Next step |
|---|---|---|
| Closes | Closes | Print the run on this paper; make a few badges first. |
| Closes | Does not close | Compare printing methods on this paper. |
| Does not close | Skip | Check the parts and assembly sequence. |
Pressing harder will not rescue heavier paper: the edge folds unevenly and the rim may crack.
If a badge made with blank paper closes but one made with the same paper after laser printing does not, the film may be slipping over the toner. Try the design inkjet-printed on the same paper stock. Use paper that suits both printers, and let the inkjet print dry fully.
If even the unprinted sample will not close
Check that the front shell, back and die set belong to one system: parts from different makers with the same diameter may not fit. Also check that no part from the previous badge is stuck in the upper die.
To match a set, send a MyPrint manager the press name, die markings, blank's product code and photos of both sides of the failed badge. If the back stays in place and only the film is damaged, include a close view of that edge. They will pick compatible parts, so you do not buy another pack at random.
