The silvery grain under cold-laminating film is often tiny pockets of air between the adhesive and the print. Apply the film slowly to a fresh print with even pressure, then compare its appearance immediately and after 24–48 hours. On pieces already laminated, fine specks often fade within 1–2 days; large bubbles and trapped debris will not disappear on their own.
Why a black background looks sprinkled with salt
Cold-film adhesive is already tacky at room temperature. Pressure helps it make contact with the surface. Air can remain in the valleys of rough paper or a textured print: it scatters light, producing whitish specks. These stand out more against black than white. Dark solids also carry the most ink, so their surface is the roughest. So the ink has not faded: the grey comes from air.
Adhesive contact with the print
Air remains in the valleys
White gaps represent air
Adhesive contacts the surface
Adhesive has filled the valleys
Cross-section: air between adhesive and print produces silvery reflections.
Inspect the piece under light from the side. Fine, even grain is silvering. A separate large bubble is a pocket of trapped air; a bump with a speck of dust or a fibre inside is contamination. Waiting will not remove them — only a fresh application will.
A fresh sample: pressure across the full width
Use a spare print with the same dark area. Keep the failed sample for comparison. First change only the application method, keeping the same film and print medium.
- Prepare the materials. Let inkjet prints dry for at least a day, dense dark solids longer; a laser print can be laminated as soon as it has cooled. Keep the film and the print in the same room so they are at the same temperature. Wipe the table, the print and the squeegee with a dry lint-free cloth. Do not blow the dust away: it will settle again.
- By hand: peel the liner gradually. Fold back 2–3 cm of liner and secure the edge. Pull the liner with one hand and smooth the film with a plastic squeegee with the other, from the fixed edge toward the free one, each stroke from the middle out to the sides. On glossy film, wrap the squeegee edge in a soft cloth so it does not scratch the gloss. Air needs an exit through an edge that has not yet bonded. Do not remove the entire liner at once or touch the adhesive with your fingers. No roll laminator? After the squeegee, run the sheet through a pouch laminator with a cold mode: its rollers press the film evenly over the whole area.
- On a cold roll laminator: even pressure and slow feed. Wipe the rollers and tighten the left and right pressure screws equally. Stick 2–3 cm of film to the leading edge of the print, feed that edge into the rollers and pull the liner back toward you as the rollers draw the sheet in. Specks in a band along one edge — add pressure on that side; evenly across the width — on both sides, about a quarter turn. Feed slowly and smoothly: about 1 m per minute, so an A4 sheet takes some 20 seconds to pass the rollers.
- Let the sample rest. Lay it flat indoors. Compare the dark area immediately, after one day and, if needed, after two. Keep the lighting the same: a reflection from a window can hide the specks.
What to do with the result after 24–48 hours
Within 1–2 days the adhesive flows into the valleys, and fine specks often disappear. Dense grain visible straight away usually stays.
For your next sample, MyPrint has plain glossy and matte cold-laminating sheets in A4 and A3. Compare gloss with gloss: specks cannot be seen on holographic or textured film, and the even dullness of matte film is not silvering.
