Where the air gets trapped
Adhesive around the bubble already touches the glass, while the centre has no contact. Pressing the middle is useless: the air has nowhere to go.
Of the pair of UV DTF A and B films, the lower A comes off before application and the upper B at the very end: you press the print through it.
An air pocket beneath the adhesive
Cross-section during application. A film has already been removed; the white area shows where adhesive does not touch the glass.
A bubble under clear B film outside the design comes away with the film. A bubble beneath the print remains on the item. Inspect the design in side light before removing B film and again after.
Work from one edge
Wash and dry a new or dirty jar first. Then wipe the application area with a lint-free cloth and isopropyl alcohol (70–99%) and let it dry: the alcohol removes grease and fingerprints and evaporates without residue. Do not use window cleaner: it can leave a film that the adhesive grips less well. The jar and transfer should be at room temperature, about 20–25 °C, with no condensation. From then on, keep your fingers off that area.
Check the position of the transfer while the adhesive is still covered and mark it with a strip of masking tape. Lay the transfer on the table, B film up, and rub the design firmly with a squeegee or a smooth plastic card. Then remove A film, leaving the print on B.
- Start at an edge. Touch one edge of the decal to the glass and keep the rest above it. On a jar, this is a vertical edge along the axis: from then on you simply rotate the jar. Choose the position beforehand: a pressed design cannot be moved without damage.
- Lower behind the squeegee. Work through B film from the bonded area toward the free area. Let each stroke overlap the previous one slightly so no unpressed strips remain. Hold the free edge above the glass until the squeegee reaches it.
- Rotate the jar. On a cylindrical wall, turn the item gradually while supporting the free part of the transfer. Do not wrap the jar with the whole transfer at once, and do not stretch the film.
- Burnish and remove B film. Rub firmly through B film over the whole design and its edges. Then peel it away slowly, folding it back at about 180°, almost parallel to the glass.
Give the air an escape route
Edges attached too soon
A closed perimeter around the pocket
Press progressively
Squeegee moves toward the free edge →
Top view. On a jar, start from a vertical edge along the axis and rotate the jar: the line of contact stays straight. Start a long wrap from a vertical strip in the middle and work the squeegee to each edge in turn.
If you can already see a bubble
Do the same voids or bumps show on an unapplied piece of the same sheet? Then the defect was there before application, and rubbing the jar will not remove it. Run a fingernail over the varnish on an offcut: if it feels tacky, raise the UV lamp power or lower the print speed on the UV DTF printer. If the varnish is hard, send your MyPrint manager photos of both pieces, the film name and your laminating settings.
Can you wet the glass?
No. UV DTF goes on dry glass: soapy water stays under the adhesive and weakens the bond. Use the wet method only if the instructions for your films describe it directly.
