If the first or last hole breaks through the top or bottom of a sheet, start by adjusting the side guide on your binding machine. If the dies still cut into the ends or leave a strip of only 1–2 mm there, disengage the end dies and centre the row again: for A5 bound on the long side with 3:1 wire, that is one die at each end. Test on a sheet already trimmed to size.
Why a hole becomes a notch
The dies have a fixed pitch. On a shorter sheet, or when you change the edge being bound, one die may straddle the end: part of the hole falls outside the paper. Pressing harder will not help — it does not move the dies.
Before fitting binding wire or a plastic comb, check both ends of the row: the margins to the top and bottom should match. For wire binding, leave about as much paper beyond the end hole as between neighbouring holes (about 4.5 mm on 3:1 pitch): a 1–2 mm strip at the end tears easily.
The row must end within the sheet
Page top ← hole row → page bottom
A die crosses the end
An open notch on the right
End dies disengaged, row centred
Intact paper at both ends
The hole pitch stays the same.
What each setting changes
| Setting | What it changes |
|---|---|
| ↔ Side guide | Shifts the whole row along the edge to balance the end margins. |
| Die disengagement | Removes one hole. The remaining holes keep the same pitch. |
| ↕ Margin depth | Moves the row farther into the sheet from the binding edge. It does not remove a notch at the top or bottom. |
Set up with a single sheet
- Trim a test sheet exactly to the block size and mark its top. For A5, that is 210 mm if you bind the long side, or 148 mm for the short side.
- Set the side guide to the A5 mark if it has one, place the sheet against it, insert it fully and punch. Adjust the guide while checking both ends. Do not angle the sheet to miss a die: the row must stay parallel to the edge. Use a fresh sheet for each trial; punching again cannot restore the paper already cut away.
- If shifting is not enough, disengage the end dies that cut into the ends. Centre the remaining row and punch a fresh sheet. For A5 bound on the long side with 3:1 wire, that is one die at each end, leaving 24 holes. Your binder’s manual shows how its dies are disengaged.
- Keep the successful sample and note the guide position and disengaged dies. Place each batch against the guide using its top edge. Lay punched sheets over the sample: the edges and the entire hole row should match. Cut an A4 wire (34 loops at 3:1) down to the number of holes — 24 loops for A5.
Ragged or crushed hole edges?
The punch is overloaded: punch fewer sheets at a time. My Print manual binders take 20–25 sheets of 80 gsm per stroke, electric ones up to 30.
Set up an oversized cover separately
Punch covers separately from the pages. If a cover is taller than the sheets, move the side guide for it: 2 mm farther from the dies in the example below. Its holes must line up with the holes in the sheets as they will lie in the finished notebook.
Sheet 210 mm, cover 214 mm
(214 − 210) ÷ 2 = 2 mm
2 mm overhang at the top
Cover
Cover top
Sheet
Sheet top
Hole centres at the same height
Top edge, close up. At the bottom the cover extends by the same 2 mm.
Lay the test cover over the test sheet with a 2 mm overhang at the top and bottom: all holes must line up.
If no guide position gives a clean row and the die you need cannot be disengaged, change the block height before printing: 2–3 mm longer or shorter is usually enough — confirm on a test sheet. For regular short-format work, choose a binder with disengageable dies.
