11.08.2026

What to do if DTF film lifts the print during peeling

DTF film lifts the print during peeling: what should you do?

If removing the film lifts the DTF image from the fabric, stop pulling. Do not try an arbitrary alternative setting on the entire order. First check the film against its instructions and repeat the process on a new control sample.

Confirm when this particular film should be peeled

Some films are peeled while hot; others after cooling. The manufacturer of the specific material determines the procedure, not the general term DTF.

Match the name and batch on the roll and packaging to the current instructions. If labelling is incomplete, contradictory or unsupported by instructions, set the material aside and ask the supplier to clarify the procedure. One accidentally successful sample does not replace that information.

Repeat the transfer on a control sample

  1. Use the same fabric, film, ink, powder and press intended for the order.
  2. Prepare and transfer according to the instructions for that combination. Do not invent a universal temperature, time or pressure.
  3. At the time specified in the instructions, begin peeling the carrier on the control sample. If the image lifts with the film, stop.
  4. If peeling is clean, inspect the entire print: fine lines, edges and solid areas must remain on the fabric.

Where the instructions permit adjustment, change only one condition. Use a new sample after each change and record the result.

Peel resistance alone does not identify the cause

A lifting print does not by itself prove a temperature, pressure, powder or fabric problem. Do not treat hot-peel film as cold-peel film based on one accidental result, or vice versa.

If a new control made with the confirmed procedure fails again, do not start production. Save material names and batches, transfer conditions and photos of the defect for a technician or supplier.

Clean peeling is only one quality check

A successful control confirms carrier release for the tested combination. It does not establish wash durability, correct powder curing or compatibility with another fabric. The other quality checks required for your product must also be completed before production.

Check MyPrint DTF film with a specified peel type. Before use, compare the product page with the packaging for the actual batch and the operator's instructions.