If colours stay put on glossy self-adhesive photo paper but the black still rubs off a day later, the driver is most likely set to “Plain Paper”. With that setting the printer prints black with its pigment text ink, which a glossy coating does not absorb. Choose the paper type “Glossy Photo Paper”, turn on colour printing and test on one sheet.
Why only the black rubs off
Many Canon, Epson, HP and Brother printers use a pigment black for text and dye colour inks. Dye ink soaks into a glossy coating, while pigment text black stays on the surface. So the colour image is already dry while the black outline still smears under a finger a day later.
The printer decides which black goes on the sheet from the paper type in the driver. For “Plain Paper” it uses pigment black. For glossy photo paper it uses a separate photo black or mixes black from the colour inks.
Paper type: plain
The black mark rubs off when touched
Paper type: glossy photo paper
The black mark stays put
The same sticker: the paper type in the driver decides which black it gets.
Do not fill the printer with a different ink for stickers: it is easier to choose paper for the ink it already uses.
One fresh test instead of another day's wait
Keep the faulty sheet for comparison. On a new sheet from the same pack, repeat a small section of the same artwork: black text, a solid black area and a coloured area.
Settings for the new test
| Paper type | “Glossy Photo Paper”, or the printer maker's glossy photo paper from the list. Not “Plain Paper”. |
|---|---|
| Colour | Colour, even for a black-and-white sticker. Turn off greyscale and black-ink-only printing. |
| Quality | High. Keep saturation and artwork unchanged so the test can be compared with the faulty sheet. |
Printing from a cutting-plotter program? Choose the paper type in the system print dialog it opens.
If the printer will not offer photo paper for A4, do not go back to “Plain Paper”: cut the sheet to a size the printer accepts as photo paper, for example 10×15 cm.
Let the test dry: MyPrint's self-adhesive photo paper cards give 10–15 seconds before touching and several minutes for dense dark areas. Then lightly wipe a dry white tissue over the black and the colour. A grey mark on the tissue means the black has not set.
What the result tells you to do
Which paper suits your ink
In MyPrint's catalogue, self-adhesive glossy photo paper is made for dye ink, and self-adhesive matte paper for both dye and pigment ink. For matte, choose “Matte Photo Paper” in the driver. If every ink in your printer is pigment, go straight to matte.
For a film label, use self-adhesive film for inkjet printing and check the ink type in the product card, just as for paper.
Cutting and laminating come after a dry test
Before cutting the run on a cutting plotter, feed a test sheet through it: after cutting, the black must stay just as clean. Laminate only a fully dry print: photo prints are usually left for a day. Laminate will not fix black that rubs off. Dye ink does not like water: laminate stickers that may get wet.
