If white heat transfer vinyl turns pink on red polyester, suspect dye migration: pressing releases dye from the fabric and it stains the film. Ordinary white film does not stop it, so first test the fabric with white paper under the press, and judge a test piece after cooling, then after 24 and 72 hours. Pressing an already pink transfer again will not whiten it and can make it darker.
Why it looked fine at the press
Heat can release dye from polyester, allowing it to move into the transfer film. A white design may turn pink on red fabric, or develop a grey or other unwanted tint on dark fabric. The colour may change straight away or over the next one to three days. Pay particular attention to saturated fabric colours and polyester with a sublimated pattern.
Show-through and dye migration are different problems. When the film is thin, the fabric shows through it, and that tint does not change over time. When dye migrates, it stains the film itself: the tint appears straight away or deepens over 72 hours. Quick check: cover the fabric with a sheet of white paper and press it for 10 s at your film’s application temperature. Colour on the paper means migration. Clean paper and a tint that stays the same for 72 hours mean show-through, which a more opaque white film will fix.
Ordinary film does not stop the dye
Ordinary heat transfer film is a colour layer plus adhesive, so the dye reaches the white layer. Only a film with a dedicated barrier stops it, and its maker then states dye-migration protection explicitly. “Suitable for polyester” only means the film bonds to that fabric. Thickness or the colour of the reverse side does not prove a barrier, and a second layer of ordinary white film hides the fabric better but does not become a barrier.
Where the dye goes
Ordinary film
Dye reaches the white layer
Film with a dye barrier
The barrier blocks the path to the white layer
Cross-section after the carrier is removed. Arrows show the dye moving out of the fabric.
Some barrier films transfer at 130–135 °C, but low heat on its own does not replace a barrier. With ordinary film, use the lowest temperature in its instructions: if they say 150–160 °C, press at 150 °C. Do not go lower, or the design will not bond well.
On close-fitting knitwear, test the design at its full size: some barrier films restrict stretch and may crack.
One trial before the whole batch
Use the same garment from the same batch. Cut a square of about 5×5 cm from the white film and apply it with a heat press at the settings from its instructions. If the fabric stained the paper, skip a long pre-press: it is one more heat cycle. If the garment will later get a number, a name or a second colour, repeat those pressings on the test too. On a multicoloured sublimated pattern, place the test so that every colour that will sit under the design is under it. Record the film name and colour, the garment batch, temperature, time and pressure, so you can repeat a successful trial in production. Let the test piece cool flat; do not stack warm garments. Keep an unpressed piece of the film for comparison.
Do not judge the white only at the press
After cooling
Photograph the test next to the unpressed piece.
After 24 hours
Compare it with the first photo.
After 72 hours
Check whether the tint is becoming stronger.
Inspect the test piece and saved film swatch under the same lighting.
Migration can also appear later, for example after a tumble dryer. After 72 hours, wash and dry the test piece as the fabric and film allow. This shows when the colour changed: before washing or after it. Check the colour and the edges of the transfer.
Still white, with firmly bonded edges
Repeat the tested combination on this batch. Test a new fabric colour or batch separately.
The design turned pink
Ordinary white film is not suitable for this fabric. Switch to a cotton garment, or to black or another dark film, where the tint does not show. An already pink design can only be covered with a darker film; try this on one garment first.
