Do not put a fresh inkjet photo behind glass straight away: dry to the touch is not yet dry. Allow at least a day between printing and framing. If haze has already appeared, first check whether it is on the glass or in the image itself.
The coating has absorbed the ink, but the print is still drying
A coating on inkjet photo paper absorbs the ink. The surface no longer smudges, but water and other volatile ink components are still leaving the coating. In a closed frame they settle on the inside of the glass as a whitish haze, often a faint copy of the dark areas of the photo. The glass looks badly cleaned, although it was clean when the frame was assembled. ‘Instant dry’ on a photo paper card means 10–15 seconds before you can handle the print, not before you can frame it.
A fresh print enclosed
Drying under a paper sheet
The image stays in the coating while moisture from the ink leaves it: under glass it settles on the glass, under a sheet of paper it soaks into the sheet.
Print today, frame after drying
A sheet of plain office paper absorbs the moisture still leaving the coating and shows you when drying is finished. The method is the same for dye and pigment inks. Dark, heavily inked images and papers with a polyethylene layer under the coating take longest — at MyPrint, those are the 260 g/m² satin and super-glossy papers — so plan two days for them from the start. If the instructions for your paper give a longer time, wait that long.
Leave the surface exposed first. Place the photo face up on a clean, flat surface for at least 15 minutes. Handle it by the edges; do not stack fresh prints.
Let dry paper absorb the moisture. Cover the image with a clean, dry sheet of plain uncoated paper larger than the printed area. Leave it for a day. A glossy sheet or plastic sleeve is not suitable for this step. Several photos can be stacked with such a sheet between each pair.
Replace the sheet if it has gone wavy. Lift it off rather than sliding it, and put a new dry sheet on for another day. If the new sheet stays flat, the photo is ready to frame; if it goes wavy again, replace it daily until it stays flat.
Do not put a fresh photo in a bag or sleeve, and do not dry it with a hair dryer, on a radiator or in direct sunlight.
If the glass is already cloudy
Open the frame and inspect the glass and photo separately under light from the side. If the photo has stuck to the glass, do not pull it off: reprint the image and dry the new print as described above.
The photo is clear without the glass; haze remains on the glass
These are ink vapours that have settled on the glass; the haze often repeats the dark areas of the photo. Wash glass with glass cleaner and dry it with a microfibre cloth; wash plastic glazing only with warm water and a drop of washing-up liquid, because ammonia cleaners cloud it. Put the photo under a sheet of office paper as described above and reassemble the frame once the sheet stays flat. No reprint is needed.
A cloudy patch remains on the photo itself
The glass is not the problem. Print the image again, dry it and inspect it without the frame. If the patch returns, change the print: take the driver paper type from the product card (Glossy Photo Paper or Matte Photo Paper). MyPrint glossy photo paper is for dye ink only; for pigment ink, choose a paper whose card lists pigment, such as the 260 g/m² satin or super-glossy. If it does not return, the old patch came from contact with the glass or condensation: frame with a mat.
Water droplets on the glass
This is water from the air or from damp frame parts. Take the frame apart and dry the glass, mat and backing separately for a day in a room at no more than 60% humidity. Do not hang the frame on a cold outside wall, in a bathroom or in a kitchen.
Assemble the frame from dry parts, with a mat or spacers keeping a gap between the photo and the glass. Print a rush order at least a day before handover, and dark images two days before.
