With inkjet fabric transfer paper, print orientation depends on which face of the image will meet the shirt. In the Light process described here, print a mirrored image and place it against the fabric. The opaque Dark process follows a different sequence: remove the backing first, place the image face-up and cover it with a protective sheet. The print therefore needs to read normally.
These are two specific inkjet transfer methods. First check printer compatibility and the application sequence in the instructions supplied with your paper: the Light or Dark label and the shirt colour do not determine every step. Special materials and laser systems may work differently.
Follow the printed face
Hypothetical example: a white cotton shirt and a navy cotton shirt both need the same design — the Ukrainian word for “print” and a right-pointing arrow, shown below. Assume compatible paper and a permitted application method for each. On the finished shirt, the arrow must point right when you look straight at the design.
Layer diagram: the print and finished design are shown from above; placement is shown in cross-section. Thicknesses are schematic. The “print” marker identifies the face of the layer that carries the image.
Light: image against fabric
1. Out of the printer
Looking at the printed face: the word is mirrored and the arrow points left.
Cross-section: top to bottom
2. Turn the sheet over
Turn the sheet face-down like a page, from left to right, keeping the top edge at the top. The backing is now uppermost and the printed face is next to the fabric.
Cross-section: top to bottom
3. After transfer
Outside view: normal reading, arrow right
The backing has been removed as instructed. From outside, we see the image through the transparent layer, from the side previously against the backing. The printed face remains next to the fabric.
Dark: image face-up
1. Out of the printer
Looking at the printed face: the word reads normally and the arrow points right.
Cross-section: top to bottom
2. Remove the backing
Separate the image-bearing layer from the backing. Place it on the fabric with the image still facing up, then cover it with the protective sheet.
Cross-section: top to bottom
Backing removed before application
3. After transfer
Outside view: normal reading, arrow right
The protective sheet has been removed as instructed. From outside, we see the same printed face as before application. The opaque layer lies between the image and the dark fabric.
With Light, viewing the image from the opposite side compensates for the mirrored print. With Dark, the backing comes away separately and the printed face stays on the outside. Removing backing does not, by itself, mirror an image.
Check what actually comes out of the printer
A symmetrical pattern can easily hide an error. A word and an arrow reveal both letter orientation and image direction. Add a word and arrow to a proof copy of your design, as in the diagrams, or choose an equally unambiguous detail already in it.
- Find the printable side, backing-removal step and placement direction in the supplied instructions. These determine how the paper proof needs to look.
- Print the proof copy on plain paper at the intended size, through the same application and with the final print settings. Look at the printed face of the sheet, not just the screen.
- Compare the result with the examples below. If its orientation does not suit your application method, correct it and repeat the plain-paper print. Move on to transfer stock only after the output is correct.
For this Light process — mirrored output
For this Dark process — normal output
Examples of the required proof orientation. The lettering size in this diagram does not set the size of your design.
Two actual mirror operations cancel each other out
Suppose you have already mirrored a Light design in your editor. If the printer driver actually applies another horizontal reflection, the word on paper will read normally again. That is the wrong output for image-down placement.
0. Original design
1. After the first reflection
2. After the second reflection
A checkbox name or transfer-paper mode does not establish that the application or driver reverses the image. Check the actual proof after all print settings have taken effect; do not count enabled option names as completed mirror operations.
Orientation is right — now try the fabric
Plain paper checks orientation only. It cannot show whether the transfer will adhere or withstand washing. Make the first application on a suitable scrap of the same fabric. Take temperature, time, pressure, backing or protective-sheet removal and care instructions from the directions for your specific material.
