28.10.2025

How to hide a notebook’s wire join behind the back cover

How to hide a notebook’s wire join behind the back cover

To hide the join in twin-loop metal binding wire, before binding, place the back cover on top of the front cover with their outside faces touching. Close the wire, then turn the back cover around the spine and underneath the block. The join will sit between it and the last sheet.

You need separate front and back covers. During binding, the back cover lies on top of the stack and the last sheet at the bottom. The wire ends meet between them, on the section of wire that wraps around the spine. When you then turn the back cover underneath the block, it hides the join.

1. Put the covers together, outside faces touching

Lay the punched block front cover up, with the holes on the left.

Take the back cover from underneath and place it on top, inside face up. Do not flip or rotate it: the top and the holes stay where they were. Leave the front cover and sheets as they are.

Stack on the table: top to bottom

Normal block

Top of notebook away from you, holes on the left

Up: outside face
Front cover
Down: inside face
Sheet 1
Sheet 2
Sheet 3
Up: inside face
Back cover
Down: outside face

Before binding

Top of notebook away from you, holes on the left

Up: inside face
Back cover
Down: outside face
Up: outside face
Front cover
Down: inside face
Sheet 1
Sheet 2
Sheet 3

The sheets stay in the same order.

2. Close the wire and turn the back cover to the rear

Load the block onto the selected wire, keeping the layers in order. Check your binding machine’s instructions for which way the wire goes into the closer and how to set it.

Once the wire is closed, hold the sheets and front cover together. Turn the back cover around the spine and underneath the block.

How the cover conceals the join

Cross-section through one loop: spine on the left, sheets to the right.

Wire closed

Join →
Back
Front
1
2
3

The back cover is still on top.

Turning the back cover

Back
inside down
Front
1
2
3

↑ Join

The join travels ahead of the cover: the wire turns in the holes.

Back cover underneath

Front
1
2
3
Join
Back

The join sits between the last sheet and the back cover.

The orange dot is the join.

3. Check the last spread

The join should sit between the last sheet and the inside of the back cover. Turn the sheets and both covers: they should move freely.

A notebook that is already bound cannot be fixed this way: the join stays on the spine between the covers. To hide it, you need a new wire.

If sheets catch or fall out, check that the loops are closed evenly along their whole length (the ends meet with no gap and the loops are not squashed) and check the wire pitch and diameter. The cover order does not affect this.